mitsubishi Workshop Repair Guides

Mitsubishi Workshop Service and Repair Manuals

Diagnostic Connector, Air Bag > < Restraints - Revised Clockspring Alignment Procedure|Page 4678
Page 7
background image

bags deployment.

CAUTION:  Wait at least 60 seconds after disconnecting the battery cable before doing any further work. 

Installation

To install reverse the removal steps and note the following.

Post-installation Inspection

1. After installing the clock spring, the steering wheel, the column covers and the air bag module, check steering wheel for noise, binds or difficult

operation.

2. Reconnect the negative battery terminal. Turn the ignition key to the "ON" position. Does the "SRS" warning light illuminate for about 7 seconds,

turn off and then remain off for at least 45 seconds? If yes, SRS system is functioning properly. If no, refer to Air Bags (Supplemental Restraint
Systems)/Testing and Inspection/Procedures.

Diagnostic Connector, Air Bag > < Restraints - Revised Clockspring Alignment Procedure|Page 4678