Montero 4WD V6-3.5L SOHC (1998)
Ball Joint: Service and Repair
Ball Joint Breakaway Torque Check
1. After shaking the ball joint stud several times, install the nut to the stud and use the special tool to measure the breakaway torque of the ball joint.
Standard value: 1.7 - 3.1 Nm (15 - 27 inch lbs.)
2. When the measured value exceeds the standard value, replace the ball joint.
3. When the measured value is lower than the standard value, check that the ball joint turns smoothly without excessive play. If so, it is possible to
use that ball joint.
Ball Joint Dust Cover Check
1. Check the dust cover for cracks or damage by pushing it with finger.
2. If the dust cover is cracked or damaged, replace the stabilizer link assembly.
NOTE: Cracks or damage of the dust cover may cause damage of the ball joint. When it is damaged during service work, replace the dust cover.
Ball Joint Dust Cover Replacement
1. Remove the clip ring and the dust cover.
2. Apply multipurpose grease to the lip and inside of the dust cover.
3. Use vinyl tape to tape the stabilizer link where shown in the illustration, and then install the dust cover to the stabilizer link.
