Montero 4WD V6-3.5L SOHC (1998)
3) Use the special tools to press-fit the new oil seal to the front hub until the oil seal is flush with the front hub end face.
Bearing Replacement
1) Wipe off any grease on the inside surface of the front hub.
2) Drive out the inner and outer bearing outer races by tapping them uniformly.
3) Apply multipurpose grease to the outside surfaces of the new inner and outer bearing outer races.
4) Use the special tools to press-fit the inner and outer bearing outer races.
NOTE: The bearing inner race and bearing outer race should be replaced as an assembly.