Montero 4WD V6-3.5L SOHC (1998)
Use a flat-tip (-) screwdriver or similar tool to remove the overdrive switch/position light connector case from the terminal.
<B> Selector Knob Removal
1. Press the knob cover downwards.
2. Remove the front and back mounting screws, and then remove the selector knob from the selector ]ever.
<C> Overdrive Switch Removal
Use a flat-tip (-) screwdriver or similar tool to remove the overdrive switch.
Reassembly Service Point
>A< Sleeve Installation
Move the selector lever to the N position and adjust the sleeve by turning it so that the distance A between the sleeve and the tip of the lever is at
the standard value.
Standard value (A): 18.2 - 18.9 mm (0.717 - 0.744 inch)
INSPECTION
-
Check the detent plate for wear.
-
Check the bushing for wear or damage.
-
Check the spring for damage or deterioration.
