Montero 4WD V6-3.5L SOHC (1998)
CAUTION: The hanger and plate must be placed so that they are parallel.
<D> Bearing Inner Race (Outer) Removal
Install special tool as shown in the illustration, and then use a press to remove the bearing inner race (outer) from the axle shaft.
<E> Bearing Outer Race Removal
Reinstall the bearing inner race that was removed previously. Use special tool and press to remove the bearing outer race.
<F> Oil Seal Removal
Remove the oil seal from the end of rear axle housing using special tool, if necessary.
Installation Service Points
>A< Oil Seal Installation
Drive the new oil seal into the rear axle housing end by using special tools.
>B< Bearing Outer Race Installation
1) Apply the multipurpose grease to the external surface of the bearing outer race.
