Montero LS 4WD V6-2972cc 3.0L SOHC 12 Valve (1994)
2. Insert fishing line [Dia 0.8 mm (.03 in.)] between the body and the side garnish and grip each end of fishing line. Cut through adhesive materia by
pulling line in a sawing motion and remove the side garnish.
3. When the side garnish is fastened with a clip, pull the side garnish toward you to remove the clip.
CAUTION:
-
To reuse the side garnish, remove it by pulling fishing line along the body so as not to damage the edges of the side garnish.
-
If it is hard to cut through adhesive material, heat it to approx. 40 degrees C (104 degrees F).
4. Peel off the tape.
5. Wipe the body surface with a rag moistened with isopropyl alcohol so that the surface is clean and free of grease.
REMOVAL OF BLIND RIVET
Use a drill [Dia 4.0-5.5 mm (.16 - .22 in.)] to break the rivet by drilling a hole, and remove the blind rivet.
INSTALLATION OF SIDE GARNISH AND OVER FENDER
