Montero LS 4WD V6-2972cc 3.0L SOHC 12 Valve (1994)
Throttle Body: Adjustments
SAS Throttle Stop Screw
NOTE: The fixed SAS has been factory-adjusted. Never attempt to adjust it as part of a normal service operation. If it has been tampered with, use the
adjustment procedure below.
1. Sufficiently slacken the accelerator cable.
2. Loosen the lock nut on the fixed SAS.
3. Sufficiently loosen the fixed SAS by turning it counterclockwise to fully close the throttle valve.
4. Turn the fixed SAS clockwise slowly to find a point at which it contacts the throttle lever (where the throttle valve starts opening) From that point,
tighten the fixed SAS 1 1/4 turns further.
5. While holding the fixed SAS to prevent it from turning, tighten the lock nut securely.
6. Adjust the accelerator cable tension.
7. Adjust the basic idle speed.
8. Adjust the closed throttle position switch and throttle position sensor (TPS).
