Montero LS 4WD V6-2972cc 3.0L SOHC 24 Valve (1996)
6. Slowly turn the throttle position sensor clockwise until the point at which the idle switch is turned off (continuity between terminals 1 and 2
changes to non-continuity) is found.
Tighten the throttle position sensor installation bolt at that position.
7. When not using the scan tool, proceed as follows.
-
Connect the special tool (test harness set) between the disconnected throttle position sensor connectors. (Connect all terminals, while being
careful not to mistake the terminal numbers.)
-
Connect a digital voltmeter between the throttle position sensor terminal 3 (sensor output) and terminal 1 (sensor ground.)
-
Turn the ignition switch ON (but do not start the engine).
8. Check the throttle position sensor output voltage. Standard value: 400-1,000 mV
9. If the voltage is outside the standard value, check the throttle position sensor and associated harnesses.
10. Remove the feeler gage.
11. Turn the ignition switch to OFF.
