Montero LS 4WD V6-2972cc 3.0L SOHC 24 Valve (1996)
HARNESS INSPECTION
STEP 1. Measure the power supply voltage of the park/neutral position switch.
-
Engine control module connector: Disconnected
-
Park/neutral position switch connector: Disconnected
-
Ignition switch: START
Voltage (V): Battery positive voltage
OK: GO TO STEP 2
NG: Check the power supply circuit.
STEP 2. Check for continuity between the park/neutral position switch and the engine control module.
-
Engine control module connector: Disconnected
-
Park/neutral position switch connector: Disconnected
NOTE:
- Touch the ohmmeter probes to both ends of the harness.
OK: GO TO STEP 3
NG: Repair the harnesses. (A5 - 71, A6 - 91)
STEP 3. Measure the park/neutral position switch terminal input voltage.
-
Engine control module connector: Connected
-
Park/neutral position switch connector: Disconnected
-
Ignition switch: ON
Voltage (V): Battery positive voltage
OK: STOP
NG: Replace the engine control module.