Montero LS 4WD V6-2972cc 3.0L SOHC 24 Valve (1996)
Technical Service Bulletin # 96-26-001
Date: 960201
CV Joint Boot - Replacement Tool/Installation
NO.: TSB-96-26-001
DATE: February, 1996
MODEL: See Below
SUBJECT:
BJ BOOT REPLACEMENT NEW SPECIAL TOOL AND INSTALLATION INSTRUCTIONS
PURPOSE
This bulletin introduces a new tool and instructions for replacing the birfield joint (BJ or outside CV joint) boot on various MMSA FWD and AWD
models. The tool, number MB991561, is used for crimping the BJ boot band (clamp) during installation.
AFFECTED VEHICLES
1991 - 96 3000GT
1992 - 96 Diamante
1990 - 96 Eclipse
1992 - 95 Expo & Expo LRV
1994 - 96 Galant
1993 - 96 Mirage
1992 - 96 Montero
1995 - 96 3000GT Spyder
SPECIAL TOOL INFORMATION
WARRANTY INFORMATION
Use standard warranty procedures.
Procedures
CAUTIONS:
^
Servicing the BJ is limited only to replacement of the boot. Never disassemble the BJ. The BJ cannot be repaired. If the BJ is worn-out or damaged,
it must be replaced.
^
The BJ boot can be installed, even though the diameter of the small end of the boot is smaller than the diameter of the axle shaft. The boot will
stretch to fit the shaft.
BIRFIELD JOINT (BJ) BOOT REPLACEMENT