Montero LTD 4WD V6-3.5L SOHC (2002)
STEP 1. Check the rear wiper.
Q: Does the rear wiper motor operate (however, the rear wiper does not stop at the predetermined park position)?
YES: Go to Step 2.
NO: Refer to Inspection Procedure H-1 "Rear wiper dose not work at all."
STEP 2. Check the rear wiper motor.
1. Disconnect rear wiper motor connector I-07.
2. While the rear wiper motor is running, disconnect the battery to stop the motor.
3. When the battery is connected as shown, the motor should run again and stop at the predetermined park position.
Q: Does the rear wiper motor operate normally?
YES: Go to Step 3.
NO: Replace the rear wiper motor. If the rear wiper operates normally, it indicates that a correct auto-stop signal is sent from the rear wiper
motor.
STEP 3. Measure at rear wiper motor connector I-07 by backprobing to check the ignition switch (ACC) line of the power supply to the rear
wiper motor.
1. Do not disconnect rear wiper motor connector I-07.
2. Turn the ignition switch to the "ACC" position.
3. Measure the voltage between terminal 4 and ground by backprobing.
-
The measured value should be approximately 12 volts (battery positive voltage).
Q: Does the measured voltage correspond with this range?
