mitsubishi Workshop Repair Guides

Mitsubishi Workshop Service and Repair Manuals

Seat Belt Systems > < SRS Control Unit <--> [Air Bag Control Module]|Specifications|Page 5554
Page 2
background image

[[A]] NEGATIVE (-) BATTERY CABLE DISCONNECTION

DANGER:  Wait at least 60 seconds after disconnecting the battery cable before doing any further work.

WARNING:  Battery posts, terminals and related accessories contain lead and lead compounds. WASH HANDS AFTER HANDLING.

Disconnect the negative battery cable from the battery and tape the terminal to prevent accidental connection and deployment.

INSTALLATION SERVICE POINTS

]]A[[ PRE-INSTALLATION INSPECTION

WARNING:  The SRS system may not operate properly if a front impact sensor is not installed properly, which could result in serious injury or
death to the vehicle's driver.

]]B[[ Attachment of bracket mounting bolt (Grounding bolt)

Check the head mark "E" on the bolt and attach the grounding bolt.

]]C[[ POST-INSTALLATION INSPECTION

1. Reconnect the negative (-) battery cable.
2. Turn the ignition switch to the "ON" position.
3. Does the "SRS" warning light illuminate for approximately seven seconds, and then go out?
4. If yes, the SRS system is functioning properly. If no, refer to SRS Warning Light Check.

Seat Belt Systems > < SRS Control Unit <--> [Air Bag Control Module]|Specifications|Page 5554