Montero Sport V6-3.5L SOHC (2004)
Drive Belt: Testing and Inspection
DRIVE BELT <For Generator, Water Pump, Power Steering Pump> (Check condition)
WATER PUMP AND GENERATOR DRIVE BELT TENSION CHECK AND ADJUSTMENT
<When using scan tool (MUT-II)
Required Special Tools:
-
MB991502: Scan Tool (MUT-II)
-
MB991668: Belt Tension Meter Set
CAUTION: To prevent damage to scan tool MB991502, always turn the ignition switch to the "LOCK" (OFF) position before connecting or
disconnecting scan tool MB991502.
1. Connect special tool MB991668 to scan tool MB991502.
2. Connect scan tool MB991502 to the data link connector.
3. Turn the ignition switch to the "ON" position and select scan tool MB991502 "Belt Tension Measurement" from the menu screen.
4. As shown in the illustration, keep the microphone (MB991668) 10 to 20 mm (0.39 - 0.79 inch) away from the back side of the belt
perpendicularly (within an inclination of ± 15 degrees).
Standard Value
5. With your finger tip lightly tap the center of the belt between the pulleys in the location shown by the arrow in the illustration to check whether the
belt vibration frequency is within the standard.