mitsubishi Workshop Repair Guides

Mitsubishi Workshop Service and Repair Manuals

Ignition Switch|Page 3949 > < Ignition Switch|Page 3947
Page 5
background image

2. Check that the voltmeter indicator deflects once when the input signal enters.

Q: Does the voltmeter indicator deflect?

YES: Replace the ETACS-ECU. Check that the malfunction is eliminated.

NO: Go to Step 3.

STEP 3. Check the driver's side door switch.

Remove the driver's side door switch.

Q: Is the driver's side door switch in good condition?

YES: Go to Step 4.

NO: Replace it. Check that the malfunction is eliminated.

STEP 4. Check the driver's side door switch ground circuit

Measure the resistance between the driver's side door switch body (metal section) and ground.

-

The measured value should be 2 Ohms or less.

Q: Does the measured resistance value correspond with this range?

YES: Go to Step 5.

NO: Repair the harness wire or connector. Then go to Step 6.

Ignition Switch|Page 3949 > < Ignition Switch|Page 3947