mitsubishi Workshop Repair Guides

Mitsubishi Workshop Service and Repair Manuals

Ignition Switch|Page 3953 > < Ignition Switch|Page 3951
Page 9
background image

2. Measure the voltage between terminal 1 and ground.

-

The measured value should be approximately 12 volts (battery positive voltage).

Q: Is the measured voltage within this specified range?

YES: Go to Step 11.

NO: Go to Step 10.

STEP 10. Check connector D-16 at the key reminder switch for damage.

Q: Is key reminder switch connector D-16 in good condition?

YES: Go to Step 11.

NO: Replace it. Then check that the malfunction is eliminated.

STEP 11. Check the harness wires between fusible link number 8 and key reminder switch connector D-16 (terminal No.1).

NOTE:  After inspecting IOD storage connector A-54X, inspect the wire. If IOD storage connector A-54X is damaged, repair or replace it. Refer to
Harness Connector Inspection.

Q: Are the harness wires between fusible link number 8 and key reminder switch connector D-16 (terminal No.1) in good condition?

YES: Go to Step 12.

NO: Repair or replace them. Then check that the malfunction is eliminated.

Ignition Switch|Page 3953 > < Ignition Switch|Page 3951