Montero Sport V6-3.5L SOHC (2004)
3. Connect special tool MB991709 to the idle air control motor connector.
4. Connect the positive terminal of a power supply (approximately 6 volts) to terminal No. 2 and the terminal No. 5.
5. Connect the negative terminal of the power supply to each clip as described in the following steps. Then check whether or not the stepper motor
vibrates slightly as it operates.
1. Connect the negative terminal of the power supply to terminal No. 1 and terminal No. 4.
2. Connect the negative terminal of the power supply to terminal No. 3 and terminal No. 4.
3. Connect the negative terminal of the power supply to terminal No. 3 and terminal No. 6.
4. Connect the negative terminal of the power supply to terminal No. 1 and terminal No. 6.
5. Connect the negative terminal of the power supply to terminal No. 1 and terminal No. 4.
6. Repeat the tests in sequence from 5 to 1 to test opposite movement of the IAC.
6. If vibration is detected during the test, the stepper motor can be considered to be normal.
