Montero Sport ES 4WD V6-3.0L SOHC (2002)
Brake Shoe: Testing and Inspection
Brake Lining Thickness Check
BRAKE LINING THICKNESS CHECK
CAUTION:
-
Whenever the shoe and lining assembly is replaced, replace both RH and LH assemblies as a set to prevent the car from pulling to one side when
braking.
-
If there is a significant difference in the thickness of the shoe and lining assemblies on the left and right sides, check the sliding condition of the
piston.
NOTE: For brake lining thickness for drum-in-disc brake, refer to Parking Brake.
1. Remove the brake drum.
2. Measure the thickness of the brake lining at the place worn the most.
Standard value: 4.7 mm (0.19 inch)
Minimum limit: 1.0 mm (0.04 inch)
Replace the shoe and lining assembly if brake lining thickness is less than the limit or if it is not worn evenly.
