Montero Sport ES 4WD V6-3.0L SOHC (2002)
NO: Repair or replace it. Refer to Harness Connector Inspection.
STEP 18. Check the input signal from the column switch (lighting switch).
1. Remove the ETACS-ECU and measure at the junction block side (connector D-11).
2. Turn the lighting switch on ("TAIL" or "HEAD" position).
3. Measure the voltage between terminal number 5 and body ground.
-
Voltage should be approximately 12 volts (battery positive voltage).
Q: Is the voltage approximately 12 volts (battery positive voltage)?
YES: Check that the malfunction eliminated.
NO: Go to Step 19.
STEP 19. Check the harness wire between ETACS-ECU connector D-11 and column switch.
NOTE: After checking junction block connector D-01 and joint connector (3) C-72, check the wires. If junction block connector D-01 and joint
connector (3) C-72 are damaged, repair or replace them. Refer to Harness Connector Inspection.
Q: Are the harness wire between ETACS-ECU connector D-11 and column switch?
