Montero Sport ES 4WD V6-3.0L SOHC (2002)
c. Pull the seat belt out the outside of the tire, and then place one tire without a wheel inside on top of the existing tire.
WARNING:
-
Before deployment and operation, check carefully to be sure that no one is nearby.
-
After the air bag has been deployed or the seat belt pre-tensioner has been triggered, the inflator is very hot. So wait for at least
thirty minutes before the inflator is handled. See Deployed Air Bag Module and Seat Belt pre-tensioner Disposal Procedures for
post-deployment handling instructions.
-
Just in case that the air bag module could not been deployed or the seat belt pre-tensioner could not been operated, contact the
MMSA Tech Line.
5. At a location as far away from the air bag module as possible, and from a shielded position, disconnect the two connected wires from each other,
and connect them to the two terminals of the battery (which has bee removed from the vehicle) to deploy the air bag and operate the seat belt
pre-tensioner.
6. For the disposal of an deployed air bag module or seat belt pre-tensioner, see the Deployed Air Bag Module Disposal Procedures.
Disposal
DEPLOYED AIR BAG MODULE DISPOSAL
After deployment and operation, the air bag module and seat belt pre-tensioner should be disposed of in the same manner as any other scrap parts,
adhering to local laws and/or legislation. Observe the following precautions during air bag disposal:
