Montero Sport ES 4WD V6-3.0L SOHC (2002)
3. Run the sensor cable along the front wiring harness, and then secure the cable to the harness with insulation tape.
4. Apply the specified sealant to the grommet cut portion.
5. Exchange the terminal of the front wiring harness connector C-17 (Rear side) shown in the illustration with the terminal of the sensor cable shown
in the illustration.
POST-INSTALLATION INSPECTION
1. Reconnect the negative (-) battery cable.
2. Turn the ignition key to the "ON" position.
3. Does the "SRS" warning light illuminate for approximately 7 seconds, and then remain off for at least 5 seconds after turning "OFF?"
4. If yes, SRS system is functioning properly. If no, refer to "SRS Diagnosis" .
