Montero Sport ES 4WD V6-3.0L SOHC (2002)
1. Install the center bearing assembly to the propeller shaft (Front) as shown in the illustration.
2. Align the mating marks on the center yoke and propeller shaft (Front).
3. Press-fit the center bearing assembly with the center yoke while tightening the self-locking nut.
>>B<< JOURNAL BEARING INSTALLATION
CAUTION: Be careful when pressing the journal bearings. If they are pressed at an angle, the inside of the journal bearings will be damaged.
1. Use Special Tool MB990840 to press the journal bearing into the yoke until the snap ring groove is fully visible.
2. Use Special Tool MB990840 and MB991410 to press the opposite side journal bearing into the yoke.
3. Align the mating marks on the yoke and propeller shaft, and install the propeller shaft journal bearings.
>>C<< SNAP RING INSTALLATION
