mitsubishi Workshop Repair Guides

Mitsubishi Workshop Service and Repair Manuals

Initial Inspection and Diagnostic Overview|Page 2832 > < Initial Inspection and Diagnostic Overview|Page 2830
Page 8
background image

STEP 11. Check the harness wires between key reminder switch connector D-16 and ETACS-ECU connector D-11 or tone alarm-ECU connector D-12.

If the harness wires between key reminder switch D-16 and ETACS-ECU D-11 or tone alarm-ECU D-12 are damaged, repair them. Check that the
malfunction is eliminated.
If the harness wire is in good condition, replace the ETACS-ECU or tone alarm-ECU. Check that the malfunction is eliminated.

NOTE:  After inspecting junction block connector D-13, Inspect the wire. If junction block connector D-13 is damaged repair or replace it.

Procedure 2 Ignition Key Illumination Light Does Not Go Out

Initial Inspection and Diagnostic Overview|Page 2832 > < Initial Inspection and Diagnostic Overview|Page 2830