Montero Sport LS 2WD V6-3.0L SOHC (1998)
STEP 4. Check the input signal from the driver's side door switch.
1. Disconnect driver's side door switch connector E-33 and measure at the harness side.
2. Measure the voltage between terminal number 2 and ground.
-
Voltage should be approximately 5 volts.
If approximately 5 volts, check that the malfunction is eliminated.
If not approximately 5 volts, go to Step 5.
STEP 5. Check the driver's side door switch connector for damage.
If harness connector E-33 is damaged, repair or replace it.
If harness connector E-33 is in good condition go to Step 6
STEP 6. Check the harness wires between driver's side door switch connector E-33 and ETACS-ECU connector D-11 or tone alarm-ECU or D-12.
If the harness wires between driver's side door switch connector E-33 and ETACS-ECU (or tone alarm-ECU) connector D-11 (or D-12) are damaged,
repair them. Check that the malfunction is eliminated.
If the harness wires are in good condition go to Step 7.
NOTE: After inspecting junction block connector 0-14 and intermediate connector E-42, inspect the wire. If junction block connector 0-14 and
intermediate connector E-24 are damaged, repair a replace them.