Montero Sport LS 2WD V6-3.0L SOHC (1998)
Keyless Entry Module: Adjustments
ETACS-ECU FUNCTION ADJUSTMENT PROCEDURE
The following functions can be adjusted by operating input swatches. The adjustments will be stored in the ECU memory even after a battery cable is
disconnected:
1. Entry conditions the adjustment mode
The ETACS-ECU sounds a tone alarm once when all of the following conditions are satisfied, and then enters the adjustment mode:
-
Data link control: "ON" (Connect scan tool MB991502 or ground the data link connector No.1 terminal.)
2. Exit conditions from the adjustment mode
The ETACS-ECU cancels the adjustment mode when any of the following conditions is satisfied:
-
Diagnosis control: "OFF" (Disconnect scan tool MB991502 or disconnect the data link connector No.1 terminal from the ground.)
-
Key reminder switch: "ON" (Pull out the ignition key.)
3. Adjustment of functions
-
Switching of keyless entry answerback function. (From activation to deactivation, or vice versa)
-
Initialization the above function (From deactivation to activation)
-
Key reminder switch: "OFF"
-
Ignition switch: "OFF"
-
Door switch: "OFF" (Close the door.)
-
If all of the conditions above are satisfied, the taillight switch will be turned on for more than 10 seconds.
-
Ignition switch: Other than "OFF"
-
Door switch: "ON" (Open the door.)
-
After the ETACS-ECU has entered the adjustment mode, no adjustment is made within 3 minutes (If any adjustment is made within 3 minutes
, the ETACS-ECU monitors a adjustment operation for other 3 minutes.)
-
Other warning tone alarm sounds