Montero Sport LS 2WD V6-3.0L SOHC (1998)
STEP 4. Check the input signal from the driver's side door switch.
1. Disconnect driver's side door switch connector E-33 and measure at the harness side.
2. Measure the voltage between terminal number 2 and ground.
-
Voltage should be approximately 5 volts.
If approximately 5 volts, check that the malfunction is eliminated.
If not approximately 5 volts, go to Step 5.
STEP 5. Check driver's side door switch connector E-33 for damage.
If. harness connector E-33 is damaged, repair or replace it.
If harness connector E-33 is in good condition, check that the malfunction is eliminated.
STEP 6. Check the harness wires between the driver's side door switch connector E-33 and ETACS-ECU connector D-11 or tone alarm-ECU D-12.
If the Harness wires between the driver's side door switch connector E-33 and ETACS-ECU or tone alarm-ECU. connector D-11 or D-12. are
damaged, repair them. Check that the malfunction is eliminated.
If the harness wires are in good condition, replace the ETACS-ECU or tone alarm-ECU. Check that the malfunction is eliminated.
NOTE: After inspecting the junction block connector 0-14 and intermediate connector E-42, inspect the wire. If the junction block connector D-14
and intermediate connector E-24 are damaged, repair or replace them.
Procedure 3 Ignition Key Illumination Light Does Not Go Out
