Montero Sport LS 2WD V6-3.0L SOHC (1998)
b.
Measure the clearance between the bump stopper and bump stopper bracket (measurement "A" in the illustration). The clearance should be
20 mm (0.78 in.).
Measure the bump stopper height (measurement "B" in the illustration). If "B" is less than 50 mm (2 in.), "A" should be more than 20 mm
(0.78 in.) by the same amount. Example: If "B" is 40 mm, adjust "A" to 30 mm.
c.
If not within specifications, adjust the clearance by tightening or loosening the adjusting nut. The clearance will change by about 1 mm per
rotation.
4.
(2WD Only) Check for a cracked appearance on the propeller shaft center bearing rubber mount. Also check to see if the shaft is centered in the
mount.
a.
If no cracking is found and the center bearing rubber mount is centered, inspect for undercoating overspray on the face of the propeller shaft.
Completely remove the undercoating from the propeller shaft face with a heavy-duty degreaser.
b.
If any cracking is found or if the center bearing rubber mount is not centered, replace the rear propeller shaft, using the appropriate part
listed in the PARTS INFORMATION section of this bulletin. (Improved design center bearing mounts have been used in vehicle production
since 10/99.)
