Montero Sport LTD 2WD V6-3.5L SOHC (2000)
After removing the oil pan mounting bolts, remove the oil pan with special tool MD998727 and brass bar.
Installation Service Points
>A< Oil Pan Upper/Oil Pan Lower Installation
1. Remove sealant from the oil pan and cylinder block mating surfaces.
2. Degrease the sealant-coated surface and the engine mating surface.
3. Apply MITSUBISHI genuine part number MD970389 or equivalent around the gasket surface of oil pan as specified in the illustration.
NOTE: The sealant should be applied in a continuous bead approximately 4.0 mm (0.16 inch) in diameter.
4. Assemble the oil pan to the cylinder block within 30 minutes after applying the sealant.
5. Tighten the bolts in order of the numbers shown in the illustration.
>B< Drain Plug Gasket Installation
Replace the gasket with a new gasket. Install the new gasket in the direction shown in the illustration.
INSPECTION
-
Check the oil pan for cracks.
-
Check the oil pan sealant-coated surface for damage and deformation.
-
Check the oil screen for cracked, clogged or damaged wire net and pipe.
