Montero Sport LTD 2WD V6-3.5L SOHC (2000)
Part 2 Of 2
Definition of Terms
DEFINITION OF TERMS
STANDARD VALUE
Indicates the value used as the standard for judging the quality of a part or assembly on inspection or the value to which the part or assembly is corrected
and adjusted. It is given by tolerance.
LIMIT
Shows the standard for judging the quality of a part or assembly on inspection and means the maximum or minimum value within which the part or
assembly must be kept functionally or in strength. It is a value established outside the range of standard value.
REFERENCE VALUE
Indicates the adjustment value prior to starting the work (presented in order to facilitate assembly and adjustment procedures, and so they can be
completed in a shorter time).
DANGER, WARNING, AND CAUTION
DANGER, WARNING, and CAUTION call special attention to a necessary action or to an action that must be avoided. The differences among
DANGER, WARNING, and CAUTION are as follows:
