Montero Sport LTD 2WD V6-3.5L SOHC (2000)
NOTE: After inspecting IOD storage connector A-54X and junction block connector D-01, inspect the wire. If IOD storage connector A-54X or
junction block connector D-01 is damaged, repair or replace it.
STEP 17. Check the input signal from the column switch (lighting switch).
1. Remove the ETACS-ECU and measure at the junction block side (connector D-11).
2. Turn the lighting switch ON ("TAIL" or "HEAD" position).
3. Measure the voltage between terminal number 5 and body ground.
-
Voltage should be approximately 12 volts (battery positive voltage).
If any circuit check made at connector D-11 does not meet specifications, go to Step 18.
If any circuit check made at connector D-11 meets specifications,check that the malfunction is eliminated.
STEP 18. Check the harness wires between ETACS-ECU connector D-11 and column switch connector D-24.
If the harness wires between ETACS-ECU connector D-11 and column switch connector D-24 are damaged, repair them, check that the malfunction is
eliminated.
