Montero Sport LTD 2WD V6-3.5L SOHC (2000)
If harness connector D-11 is damaged, repair or replace it. Refer to Harness Connector Inspection.
If harness connector D-11 is in good condition, go to Step 4.
STEP 4. Check the harness wires between the ignition switch (IG1) and ETACS-ECU connector D-11.
If the harness wires between the ignition switch and ETACS-ECU connector D-1 1 are damaged, repair them.Check that the malfunction is eliminated.
If the harness wires are in good condition, replace the ETACS-ECU. Check that the malfunction is eliminated.
NOTE: After inspecting junction block connector D-08, inspect the wire. If junction block connector D-08 is damaged, repair or replace
it. Refer to Harness Connector Inspection.
4.Ign. Key Tone Alarm Does Not Stop When Key Is Removed.
The Ignition Key Remainder Tone Alarm Does Not Stop Sounding By Removing the Ignition Key (The Tone Alarm Stops Sounding By Closing
the Driver's Door)
