Montero Sport LTD 2WD V6-3.5L SOHC (2000)
<A> NEGATIVE (-) BATTERY CABLE DISCONNECTION
DANGER: Wait at least 60 seconds after disconnecting the battery cable before doing any further work.
Disconnect the negative (-) battery cable from the battery and tape the terminal to prevent accidental connection and air bag(s) deployment.
<E> AIR BAG MODULE REMOVAL (FRONT PASSENGER'S SIDE)
WARNING: The removed air bag module should be stored in a clean, dry place with the pad cover face up.
INSTALLATION SERVICE POINTS
<A> PRE-INSTALLATION INSPECTION
WARNING: Dispose of air bag modules only according to the specified procedure.
1. When installing the new air bag modules and clock spring, refer to "INSPECTION" .
2. Connect the negative (-) battery cable.
CAUTION: Turn "OFF" the ignition switch before connecting or disconnecting scan tool MB991502.
3. Connect scan tool MB991502 to the data link connector.
4. Turn the ignition key to the "ON" position.
5. Conduct diagnostic test using scan tool MB991502 to ensure entire SRS operates properly.
WARNING: Wait at least 60 seconds after disconnecting the battery cable before doing any further work.
6. Turn the ignition key to the "OFF" position. Disconnect the negative (-) battery cable and tape the terminal to prevent accidental connection and
air bags deployment.
<E> POST-INSTALLATION INSPECTION
1. Reconnect the negative (-) battery cable.
2. Turn the ignition key to the "ON" position.
3. Does the "SRS" warning light illuminate for approximately seven seconds, and then remain off for at least five seconds after turning "OFF?"
4. If yes, the SRS system is functioning properly. If no, consult SRS Diagnosis.
Air Bag Modules, Clock Spring and Steering Wheel
WARNING:
1. Never attempt to disassemble or repair the air bag modules or clock spring. If faulty, replace it.
2. Do not drop the air bag modules or clock spring or allow contact with water, grease or oil
Replace it if a dent, crack, deformation or rust is detected.
3. The air bag modules should be stored on a flat surface and placed so that the pad surface is facing upward. Do not place anything on top
