mitsubishi Workshop Repair Guides

Mitsubishi Workshop Service and Repair Manuals

Component Locations|Page 4861 > < Component Locations|Page 4859
Page 1
background image

SRS Control Unit: Service and Repair

WARNING:

1. Never attempt to disassemble or repair the SRS-ECU. If faulty, replace it.
2. Do not drop or subject the SRS-ECU to impact or vibration.

If denting, cracking, deformation, or rust are discovered in the SRS-ECU, replace it with a new SRS-ECU. Discard the old one.

3. After deployment of an air bag, replace the SRS-ECU with a new one.
4. Never use an ohmmeter on or near the SRS-ECU, and use only the special test equipment.

Pre-removal operation

Turn the ignition switch to the "OFF" position.
Floor Console Removal.

REMOVAL SERVICE POINT

<A> NEGATIVE (-) BATTERY CABLE DISCONNECTION

Disconnect the negative battery cable from the battery and tape the terminal to prevent accidental connection and deployment.

DANGER:  Wait at least 60 seconds after disconnecting the battery cable before doing any further work.

INSTALLATION SERVICE POINTS

<A> SRS-ECU INSTALLATION

Component Locations|Page 4861 > < Component Locations|Page 4859