Montero Sport LTD 2WD V6-3.5L SOHC (2000)
CAUTION: When the rear anchor arm adjusting nut is loosened, use a jack to support the lower arm of the side to be loosened.
Loosen the anchor arm bolt of the torsion bar all the way.
<B> Upper Arm Ball Joint Disconnection
WARNING: Support special tool MB991113 or MB990635 with a cord, etc. to prevent it from coming off.
Use special tools MB9g1113 or MB990635 to disconnect the upper arm ball joint form the knuckle.
NOTE: Only loosen the mounting nut, do not remove it from the ball joint.
<C> Shims Removal
NOTE: The camber and caster adjustment shims should be kept for use during assembly.
Installation Service Points
>A< Upper Arm Installation
Install the upper arm so that the "OUT" mark on the upper arm shaft is facing toward the outside of the vehicle.
>B< Rebound Stopper Installation
Install the rebound stopper so that its arrow faces inside of the vehicle.
>C< Bump Stopper And Bump Stopper Bracket Clearance Adjustment
