Montero Sport LTD 2WD V6-3.5L SOHC (2000)
3. Install a dial gauge as shown in the illustration, and then move the hub in the axial direction and measure how far the front wheel bearing
moves.
Standard value: 0.05 mm (0.002 inch) or less
4. If the distance exceeds the standard value, remove the spring washer and use special tool MB990954 to tighten the jam nut.
5. If adjustment is not possible, disassemble the hub and inspect each part.
>D< DRIVESHAFT END PLAY ADJUSTMENT <4WD>
1. Push the driveshaft in by hand towards the knuckle until they touch.
2. Measure the clearance between the drive flange and the spacer with a feeler gauge as shown in the illustration.
Standard value: 0.4 - 0.7 mm (0.02 - 0.03 inch)
3. If the amount of play is not within the standard value, adjust by selecting a shim that will bring the play to the standard value.
