Montero Sport LTD 4WD V6-3.5L SOHC (1999)
Hydraulic Assembly: Testing and Inspection
Required Special Tool: MB991502: Scan Tool (MUT-II)
CAUTION:
-
Turn the ignition switch "OFF" before connecting or disconnecting scan tool MB991502.
-
The roller of the braking force tester and the tire should be dry during testing.
-
When testing the front brakes, apply the parking brake. When testing the rear brakes, stop the front wheels with chocks.
1. Jack up the vehicle. Then support the vehicle with rigid racks at the specified jack-up points or place the front or rear wheels on the rollers of the
braking force tester.
2. Release the parking brake, and feel the drag force (drag torque) on each road wheel. When using the braking force tester, take a reading of the
brake drag force.
3. Turn the ignition key to the "OFF" position and set scan tool MB991502 as shown in the diagram.
4. After checking that the shift lever <M/T> or the selector lever <A/T> is in neutral, start the engine.
5. Use scan tool MB991502 to force-drive the actuator.
NOTE:
-
The ABS system will switch to the scan tool mode and the ABS warning light will illuminate.
-
When the ABS has been interrupted by the fail-safe function, scan tool MB991502 actuator testing cannot be used.
