Montero Sport LTD 4WD V6-3.5L SOHC (1999)
Snap Ring/Stop Ring Removal
1. Press a long socket wrench of appropriate size to the stop ring. Then tap the socket wrench to remove the stop ring to the pinion gear side.
Snap Ring/Stop Ring Removal
2. After removing the snap ring (by using snap-ring pliers), remove the stop ring and the overrunning clutch.
STARTER MOTOR PART CLEANING
1. Do not immerse parts in cleaning solvent. Immersing the yoke and field coil assembly and/or armature will damage insulation. Wipe these parts
with a shop towel only.
2. Do not immerse the drive unit in cleaning solvent. Overrunning clutch is pre-lubricated at the factory and solvent will wash lubrication from the
clutch.
3. The drive unit may be cleaned with a brush moistened with cleaning solvent and wiped dry with a shop towel.
ASSEMBLY SERVICE POINT
>A<
STOP RING AND SNAP RING INSTALLATION
Stop Ring/Snap Ring Installation
Using a suitable pulling tool, pull the overrunning clutch stop ring over the snap ring.
