Montero Sport LTD 4WD V6-3.5L SOHC (1999)
CAUTION: Adjust by turning the adjusting bolt so that the breakaway torque at the center position of the rack piston is approximately 0.2 Nm
(1.8 inch lbs.) higher than the values at the both ends of the rack piston.
1. While turning the adjusting bolt, measure the mainshaft total breakaway torque by using special tool MB990228 or M13991006.
Standard value: 0.69 - 1.28 Nm (6 - 12 inch lbs.)
2. Tighten the adjusting bolt jam nut to the specified torque.
Tightening torque: 37 Nm (27 ft. lbs.)
>N< Pitman Arm Installation
Install the pitman arm to the gear box with the mating marks aligned.
INSPECTION
Dust Cover Replacement
When the dust cover is damaged accidentally during service work, replace the dust cover only as follows:
1. Fill inside the dust cover with multipurpose grease.
2. Apply the 3M ATD Part number 8661 or equivalent to the mounting surface of the dust cover at the pitman arm.
3. Using special tool M13990776, install the dust cover to the pitman arm.
4. Press the dust cover with a finger to check whether the dust cover is cracked or damaged.
