1999 Mitsubishi Montero Sport LTD 4WD V6-35L Tie Rod End Specifications
1. Apply multipurpose grease to the threaded section of the tie rod end.
2. Screw in the right and left tie rod ends to the pipe by the same amount, and then and provisionally tighten the tie rod end fixing nut.
INSPECTION
Idler Arm Sliding Resistance
Standard value: 2.4 16 N (0.5 - 3.6 lbs) [0.3 2.0 Nm] (2.7 - 17.7 inch lbs.)
Dust Cover Replacement
When the dust cover is damaged accidentally during service work, replace the dust cover only as follows:
1. Fill inside the dust cover with multipurpose grease.
2. Apply the 3M ATD Part number 8663 or equivalent to the dust cover lip.
3. Using special tool MB990776, install the dust cover to the tie rod end ball joint.
4. Press the dust cover with a finger to check whether the dust cover is cracked or damaged.
