Montero Sport XLS 4WD V6-3.5L SOHC (2002)
Lateral Accelerometer: Service and Repair
REMOVAL AND INSTALLATION
CAUTION: Do not drop or apply a shock on the G-sensor.
G-SENSOR CHECK
Required Special Tool:
-
MB991348: Test Harness Set
1. Disconnect the G-sensor connector and connect special tool, MB991348, between terminals of the disconnected connector.
2. With the ignition switch turned to the "ON" position, read the voltage between terminals number 2 and number 3.
Standard Value: 2.4 - 2.6 V
3. With special tool MB991348 connected, rotate so that the arrow faces straight down. Read output voltage between terminals number 2 and number
3.
Standard Value: 3.4 - 3.6 V
4. If the voltage deviates from the standard value, make sure that nothing is wrong with the power supply wire and ground wire and then replace the
G-sensor.
