Montero Sport XLS 4WD V6-3.5L SOHC (2002)
Refer to the illustrations shown along with the application chart in the PARTS INFORMATION section of this bulletin to identify engine core plug
locations and block heater installation position.
Block Heater Element Location and Direction
NOTE:
Position indicated by direction of the heater coils, not the electrical connector.
Block Heater Installation
WARNING
To avoid personal injury, be sure to safely release the pressure from the cooling system and drain the coolant before installing the block heater.
In addition to the instructions supplied with the block heater, refer to the following installation and usage procedures:
1.
Locate the appropriate core plug location and remove the core plug (see above). Do not attempt to install the block heater in a core plug location
not specified in this bulletin.
2.
Lubricate the 0-ring with clean engine coolant.
3.
Insert the block heater with the heating element pointed in the proper direction as indicated on the application chart in the PARTS
INFORMATION section of this bulletin.
4.
Tighten the block heater screw to the exact torque specified in the installation instructions.
5.
Firmly attach the power cord to the block heater. Route the cord away from hot or moving parts in the engine compartment.
6.
Fill the cooling system with a clean, properly mixed ratio (normally 50/50) of coolant and water. Do not use cooling system additives designed to
