Montero Sport XLS 4WD V6-3.5L SOHC (2002)
NOTE: After inspecting intermediate connector C-01 and C-41, junction block connectors D-06, D-08 and IOD or storage connector A-54X, inspect
the wire. If intermediate connector C-01 and C-41, junction block connectors D-06, D-08, and IOD or storage connector A-54X are damaged, repair or
replace them. Refer to Harness Connector Inspection .
Q: Is the harness wires between inside rear view mirror (with compass and temperature display) connector E-59 and ignition switch (ACC) in
good condition?
YES: Go to Step 6.
NO: Repair them. Then go to Step 6.
STEP 4. Check the inside rear view mirror (with compass and temperature display) ground circuit.
1. Remove the inside rear view mirror (with compass and temperature display).
2. Disconnect the connector
3. Check at inside rear view mirror (with compass and temperature display) harness side connector (front side) E-59.
Q: Is the resistance between terminal 3 and body ground less than 2 ohms?
YES: Go to Step 6.
NO: Go to Step 5.
