Montero Sport XLS 4WD V6-3.5L SOHC (2002)
CAUTION:
-
Measure when the belt surface temperature is close to room temperature.
-
Make sure that water or oil, etc., does not get on the microphone.
-
If a strong wind blows or noise is made close to the microphone during measure, the meter will show a value that differs from the actual value.
-
If the measurement is taken with the microphone touching the belt, the meter will show a value that differs from the actual value.
-
Do not measure while the engine is running.
<When not using scan tool (MUT-II)>
Standard Value
1. Use a belt tension gauge to check that the belt tension is at the standard value at a point half-way between the two pulleys (indicated by an arrow in
the illustration). In addition, press this section with a force of 98 N (22 lb) and check that the amount of the belt deflection is at the standard value.
Standard Value
2. If the tension or deflection is not within the standard value, adjust by the following procedure.
1. Loosen the tension pulley fixing nut.
