Montero Sport XLS 4WD V6-3.5L SOHC (2002)
Attachment A lists the PCM part numbers, ROM IDs, and corresponding vendor numbers that will display after reprogramming.
a.
After reprogramming is completed, the new ENG ROM ID and new All ROM ID will display alternately with the message "Turn IG SW OFF"
every four seconds. Note this information. Verify that the new PCM part number and ROM IDs are the same as those listed in Attachment A of
this bulletin.
10.
Using a ball-point pen, enter the appropriate PCM part number, vendor number, ROM ID #, this TSB number (TSB-04-13-002REV), your dealer
code, and the current date on the Engine Compartment / Control Module Label (part no. MSSF-024G-00).
11.
Carefully remove all dirt and oil from a vacant area near the VECI label on the underside of the hood, and affix the Engine Compartment label.
12.
Affix the Control Module label to the PCM.
13.
If DTC P0154 was set in the PCM before starting this procedure, replace the Bank 2, Sensor 2 (left rear) oxygen sensor. (The failed oxygen sensor
