Montero Sport XLS 4WD V6-3.5L SOHC (2002)
CAUTION: When the rear anchor arm adjusting nut is loosened, use a jack to support the lower arm of the side to be loosened. Loosen the
anchor arm bolt of the torsion bar all the way.
<<B>> UPPER ARM BALL JOINT DISCONNECTION
WARNING: Support special tool MB991113 or MB990635 with a cord, etc. to prevent it from coming off.
Use special tools MB991113 or MB990635 to disconnect the upper arm ball joint form the knuckle.
NOTE: Only loosen the mounting nut, do not remove it from the ball joint.
<<C>> SHIMS REMOVAL
NOTE: The camber and caster adjustment shims should be kept for use during assembly.
INSTALLATION SERVICE POINTS
>>A<< UPPER ARM INSTALLATION
Install the upper arm so that the "OUT" mark on the upper arm shaft is facing toward the outside of the vehicle.
>>B<< REBOUND STOPPER INSTALLATION
Install the rebound stopper so that its arrow faces inside of the vehicle.
>>C<< BUMP STOPPER AND BUMP STOPPER BRACKET CLEARANCE ADJUSTMENT