Montero Sport XLS 4WD V6-3.5L SOHC (2002)
After removing the oil pan mounting bolts, remove the oil pan with special tool MD998727 and a brass bar.
INSTALLATION SERVICE POINT
>>A<< OIL PAN INSTALLATION
1. Remove sealant from the oil pan and transmission case mating surfaces.
2. Degrease the sealant-coated surface and the transmission mating surface.
3. Clean the magnet and install it in the hollow of the oil pan base.
NOTE: If the Oil pan is replaced, reuse the cleaned magnet.
4. Apply MITSUBISHI GENUINE PART number MD166584 or equivalent around the gasket surface of the oil pan as specified in the
illustration.
NOTE: The sealant should be applied in a continuous bead approximately 3 mm (0.1 inch) in diameter.
5. Tighten the mounting bolts to the specified torque.
Tightening torque: 11 Nm (98 inch lbs.)
