Montero Sport XS 2WD V6-3.5L SOHC (2001)
STEP 19. Check the harness wire between ETACS-ECU connector D-11 and column switch.
NOTE: After checking junction block connector D-01 and joint connector (3) C-72, check the wires. If junction block connector D-01 and joint
connector (3) C-72 are damaged, repair or replace them. Refer to Harness Connector Inspection.
Q: Are the harness wire between ETACS-ECU connector D-11 and column switch?
YES: Go to Step 20.
NO: Repair or replace it. Refer to Harness Connector Inspection.
STEP 20. Recheck for malfunction.
Q: Is a malfunction eliminated?
YES: This diagnosis is complete. (If no malfunctions are not found in all steps, an intermittent malfunction is suspected. Refer to How to Use
Troubleshooting/Inspection Service Point.)
NO: Go to step 1 or go to step 2.
