mitsubishi Workshop Repair Guides

Mitsubishi Workshop Service and Repair Manuals

Symptom Related Diagnostic Procedures|Page 2956 > < Symptom Related Diagnostic Procedures|Page 2954
Page 24
background image

STEP 12. Check the harness wire between key reminder switch connector D-16 and ETACS-ECU connector D-11.

NOTE:  After checking intermediate connector C-72 and D-13, check the wires. If intermediate connector C-72 and D-13 are damaged, repair or replace
them. Refer to Harness Connector Inspection.

Q: Is the harness wire between key reminder switch D-16 and ETACS-ECU connector D-11 in good condition?

YES: Go to Step 13.

NO: Repair or replace it. Refer to Harness Connector Inspection.

STEP 13. Recheck for malfunction.

Q: Is a malfunction eliminated?

YES: This diagnosis is complete. (If no malfunctions are not found in all steps, an intermittent malfunction is suspected. Refer to How to Use
Troubleshooting/Inspection Service Point.)

NO: Go to step 1.

Symptom Related Diagnostic Procedures|Page 2956 > < Symptom Related Diagnostic Procedures|Page 2954