mitsubishi Workshop Repair Guides

Mitsubishi Workshop Service and Repair Manuals

Symptom Related Diagnostic Procedures|Page 2114 > < Symptom Related Diagnostic Procedures|Page 2112
Page 18
background image

STEP 6. Check the harness wire between key reminder switch connector D-16 and body ground.

Q: Is the resistance wore between key reminder switch D-16 and body ground

YES: Replace the ETACS-ECU. Then Go to Step 7.

NO: Repair or replace it. Refer to Harness Connector Inspection.

STEP 7. Check the harness wire between key reminder switch connector D-1 6 and ETACS-ECU connector D-11.

NOTE:  After checking intermediate connector C-72 and D-13, check the wires. If intermediate connector C-72 and D-13 are damaged, repair or replace
them. Refer to Harness Connector Inspection.

Q: Is the harness wire between key reminder switch D-16 and ETACS-ECU connector D-11 in good condition?

YES: Go to Step 8.

NO: Repair or replace it. Refer to Harness Connector Inspection.

Symptom Related Diagnostic Procedures|Page 2114 > < Symptom Related Diagnostic Procedures|Page 2112