Montero Sport XS 2WD V6-3.5L SOHC (2001)
STEP 7. Check the harness wires between driver's side door switch connector E-33 and ETACS connector D-11.
NOTE: After inspecting junction block connector D-14 and intermediate connector E-42, inspect the wire. If junction block connector D-14 and
intermediate connector E-42 are damaged, repair or replace them. Refer to Harness Connector Inspection.
Q: Are the harness wire between driver's side door switch connector E-33 and ETACS connector D-11 in good condition?
YES: Go to Step 8.
NO: Repair them. Then check that the malfunction is eliminated.
STEP 8. Check the continuity of the key reminder switch.
1. Remove the driver's side under cover.
2. Remove the column covers, lower and upper.
3. Disconnect wiring connector D-16 from the key reminder switch and measure at the key reminder switch side.
4. Measure the resistance between terminal numbers 4 and 6.
Q: Is the resistance value less than two Ohms?
YES: Go to Step 9.
NO: Replace the key reminder switch. Then check that the malfunction is eliminated.
