mitsubishi Workshop Repair Guides

Mitsubishi Workshop Service and Repair Manuals

SRS Control Unit (SRS-ECU)|Page 5306 > < SRS Control Unit (SRS-ECU)
Page 2
background image

WARNING:  Battery posts, terminals and related accessories contain lead and lead compounds. WASH HANDS AFTER HANDLING.

Disconnect the negative (-) battery cable from the battery and tape the terminal to prevent accidental connection and deployment.

INSTALLATION SERVICE POINTS

]]A[[ SRS-ECU INSPECTION

WARNING:  The SRS may not active if the SRS-ECU is not installed properly, which could result in serious injury or death to the vehicle's
driver or front passenger.

]]B[[ POST-INSTALLATION INSPECTION

1. Reconnect the negative (-) battery cable.
2. Turn the ignition key to the "ON"  position.
3. Does the "SRS" warning light illuminate for approximately 7 seconds, and then remain off for at least 5 seconds after turning "OFF"?
4. If yes, the SRS system is functioning properly. If no, consult SYMPTOM CHART.

SRS Control Unit (SRS-ECU)|Page 5306 > < SRS Control Unit (SRS-ECU)